1. Clean only with Rapid Tac or Rapid Tac II. DO NOT use glass cleaners, alcohol or solvents. Wipe only with cheap kitchen paper towels. All other paper towels contain chemicals in order to be classified as lint/static free or super absorbent. These chemicals contaminate the surface. Also avoid using cloth towels or rags. Note: Glass must be cleaned 2 times with Rapid Tac or Rapid Tac II for best results.

2. Spray surface again with Rapid Tac or Rapid Tac II. Peel backing off decal and place on wet panel. You may spray adhesive side of decal.

3. Align decal. At this point you can still pick up the decal off the surface and re-align it until it is in the desired position. If the surface is beginning to dry, spray on more Rapid Tac or Rapid Tac II and place the decal back down. Once the decal is in the desired position use squeegee to remove fluid, using a good deal of pressure and working from the center out in all directions.

4. Wait 2 to 3 minutes. If decal is covered in a mask or transfer tape, saturate it with Rapid Tac or Rapid Tac II and remove the tape. Wipe with paper towel and your application is complete.